Aircon Gas Leak Test in Singapore: One Unit or Every Unit? When $180 Is Enough and When It Is Not

Guide ยท November 20, 2026 ยท By aircons.sg Editorial

Aircon Gas Leak Test in Singapore: One Unit or Every Unit? When $180 Is Enough and When It Is Not

Pictured above: a pressure gauge on an aircon line during a nitrogen pressure test on one of our jobs, a Daikin System 3 in a Bukit Panjang condo. On that job the gauges went onto the lines of all three fan coil units. Whether you pay to test one indoor unit or every unit on your system comes down to a single question that the price list answers in one short line, and most people only notice it when the quote arrives: do you already know which unit is leaking?

This guide is for anyone who has been told "you probably have a gas leak" on a multi-unit system and now has to decide what to approve. It uses only the prices we publish, and it flags the places where the price list does not tell you something and you need to ask.

What the price list says about the test

On our pricing page the gas leak job is two steps. Step 1 is the nitrogen pressure test, which finds exactly which pipe is leaking. Step 2 is the leak repair, and it only happens if it is needed once the leak is found. The test is priced per indoor unit tested, not per system:

Units testedNitrogen pressure test
1 unit (only if you know which unit leaks)$180
System 2, 2 units$360
System 3, 3 units$540
System 4, 4 units$720

Two lines sit beside that table and they matter as much as the dollar figures. The $180 for a single unit applies only if you know which unit leaks. And the aircon cannot be used for 2 to 3 days while the test is done.

Why "which unit" is the whole question

A System 2, 3 or 4 has several indoor units on one outdoor unit. In a typical Singapore flat that means a System 2 for a 3-room flat, a System 3 for a 4-room and a System 4 for a 5-room or executive flat, though the right system is always confirmed at a survey. When gas leaks out of a system like that, the leak is in one particular pipe run or joint, but the symptom, a room that will not cool, is felt through the whole system.

That is our reading, not a published rule, but it is why we would not treat "the bedroom is the weakest room" as proof that the bedroom unit is the leaking one. It is a clue. The test is what turns a clue into a finding, and the price list charges for the test by the unit.

When you can honestly say "this unit"

You are in the $180 case only if you can point at one unit with something better than a hunch. These are the situations where that is fair:

  • A technician has already located it. They took a reading and told you which unit or which pipe. Ask for that finding in writing on WhatsApp, with the reading, so the next company is not starting from nothing.
  • You can see or hear it on one unit. Our gas leak page lists the signs: hissing from an indoor unit or along its piping, and ice forming on the copper pipes or the indoor coil. If it is one unit's pipes that are iced, and the others are fine, that points to it.
  • The same unit has been opened up before. If a previous job touched one unit's pipework and the gas loss started afterwards, say so. It does not prove anything, but it tells the technician where to start.

These are the situations where it is not fair: all the rooms are weak, the last top-up lasted a few weeks and nobody has said where the gas went, or the only evidence is that one room "feels" worse. In those cases, plan for the whole system.

The arithmetic on a System 3, from the published prices

Take a 4-room flat on a System 3, in an HDB. Our pricing page gives a worked example: one leak found, $540 for the test plus $520 for the repair, so $1,060 in total. Here is how the same flat looks if you can name the unit, and if you cannot. Everything below is addition of published figures, nothing else.

CaseWhat you pay
Test all 3 units, one leak found, HDB repair$540 + $520 = $1,060
Test all 3 units, one leak found, condo repair$540 + $700 = $1,240
Name the right unit, test 1 unit, HDB repair$180 + $520 = $700
Name the wrong unit, test it, then test the other 2, HDB repair$180 + $360 + $520 = $1,060

The last row is the one worth reading twice. On the published prices, a wrong guess followed by testing the other two units comes to the same $540 as testing all three at the start, so the guess does not cost extra dollars on the test line. What it costs is time: the aircon is out for 2 to 3 days, and a second round of testing would mean going through that again. We do not publish whether a second visit carries its own charge, so that is a question to put to any company, including us, before you pick the cheaper-looking route.

Naming the right unit saves $360 on a System 3. Naming the wrong one costs nothing extra in dollars but adds days. Not knowing and testing everything costs the same as the wrong guess and takes the days once. That is why, when you honestly do not know, testing the whole system in one go is the cleaner choice.

Where a top-up fits in

The cheaper-looking option is usually a gas top-up, which is priced per outdoor circuit, not per indoor unit: R22 $115, R410A $130, R32 $170. It is one charge for the system, however many indoor units it has. For a very slow leak that loses gas over a year or more, an occasional top-up can be a sensible choice, and we say so when it is.

For a leak that empties the system in weeks, the arithmetic turns. Two R32 top-ups are $340, about the price of testing a System 2. Three are $510, within $10 of an HDB leak repair at $520. A top-up on a leaking system is buying time, not fixing it. Our guide to checking a gas leak quote before you approve it has the full top-up versus repair table, and the guide on where refrigerant actually escapes covers where the loss usually turns out to be.

What the test does not do

  • It does not repair anything. It finds the pipe. Repair is Step 2: HDB $520, condo $700 for a leaking pipe change, on the figures on our pricing page. A re-made joint, a corroded coil or concealed pipe work is quoted after the test, and a compressor issue is quoted separately because the price varies by model and by refurbished or brand-new unit.
  • It does not commit you to the repair. You see the finding and an exact quote before any work starts. If you decide not to go ahead, you pay for the visit and any pressure test already carried out, and nothing towards the repair.
  • It does not replace the pre-check. The visit itself, with the 9-point pre-check and its gas pressure check, is $55. That check is how a leak first shows up, as low pressure on the gauge, and it is done before anyone proposes a test.

Repair work is covered by a 90-day workmanship warranty. For what to do with that window after the work, see how to tell a gas leak repair held.

Six questions to put to any company before you approve a test

  1. Which unit or units are you testing, and is the price per unit? A single "gas leak test" figure on a System 3 hides whether it covers one unit or three.
  2. What is that based on? A reading and a location, or a statement that the location is still unknown. "The gas is low" is a finding. "The pressure fell at this joint" is a diagnosis.
  3. If the unit you test turns out sealed, what happens next and what does it cost? This is the wrong-guess row of the table above, in your own quote.
  4. For how many days is the aircon out of use, and is that the whole system or only the unit being tested? Our price list says the aircon cannot be used for 2 to 3 days. It does not say which rooms that covers on a System 3, so ask for your own system. Our post on planning for the days without the unit goes through how to plan around it.
  5. Is the repair on the same visit or a separate one? It changes how many times you lose the unit and how many separate bills there are.
  6. What do I pay if I stop after the test? The answer should be the visit and the test already done, and nothing for the repair.

Ask for the answers on WhatsApp rather than by phone, so you have a message to scroll back to when you compare two companies on the same footing.

What to have ready before you book

  • How many indoor units, and whether it is an HDB flat, condo or landed home.
  • Which room went weak first, and which rooms still cool normally.
  • A photo of the nameplate sticker on the outdoor unit, which shows the refrigerant.
  • When the gas was last topped up, and how long it lasted.
  • Any ice on a unit's pipes, or any hissing, and which unit it was.

With those five answers we can tell you which check applies and the published price before we come. Our aircon gas leak repair cost page has the full price list and the signs, the pressure test cost page explains the test itself, and every figure above comes from the pricing page. You can also see the Bukit Panjang test from the photo above on its live job page.

The short version

  • The nitrogen pressure test is $180 per indoor unit tested. One unit is $180 only if you know which unit leaks; a System 2 is $360, a System 3 $540, a System 4 $720.
  • If you cannot point at the unit with something better than a hunch, test the whole system once rather than guess and go back.
  • A wrong guess followed by testing the rest costs the same in dollars on a System 3, and one more round of days without the aircon.
  • A top-up is per outdoor circuit and is not a diagnosis. If the last one lasted weeks, stop topping up.
  • You approve any repair before work starts. If you stop after the test, you pay for the visit and the test already carried out.

If you want a straight answer for your own system

Tell us the number of units, the property type, what you have seen and when the last top-up was. We give you the price before we come. WhatsApp us on 9107 2601 and we will tell you which check applies and what to expect.

Frequently asked questions

How much does an aircon nitrogen pressure test cost in Singapore?
At aircons.sg the nitrogen pressure test is $180 per indoor unit tested: 1 unit $180, System 2 (2 units) $360, System 3 (3 units) $540 and System 4 (4 units) $720. The aircon cannot be used for 2 to 3 days while it is done. The test only finds the leaking pipe; any repair is a separate step that you approve before work starts.
Can I test just one unit on a System 3?
The published $180 for a single unit applies only if you know which unit leaks. If you cannot point at the unit with a reading, a located leak or a visible sign such as ice or hissing on that unit, plan for every indoor unit on the system: $540 for a System 3.
What happens if I test the wrong unit first?
On the published prices, testing one unit at $180 and then the other two at $360 comes to $540, the same as testing all three at once. The cost is time, because the aircon is out for 2 to 3 days each round. We do not publish whether a second visit has its own charge, so ask before you choose to test in stages.
Does the pressure test fix the gas leak?
No. The test finds which pipe is leaking. The repair is Step 2 and only happens if it is needed: a leaking pipe change is HDB $520 or condo $700, while a re-made joint, a corroded coil or concealed pipe work is quoted after the test and a compressor issue is quoted separately. You see the finding and an exact quote before any work starts, and repair work carries a 90-day workmanship warranty.
What do I pay if I stop after the pressure test?
If you decide not to go ahead with the repair, you pay for the visit and any pressure test already carried out, and nothing towards the repair.
Is a gas top-up cheaper than testing for the leak?
A top-up is a flat price per outdoor circuit: R22 $115, R410A $130, R32 $170. It is cheaper on the day, but it does not find or fix a leak. If your last top-up lasted only a few weeks, stop topping up and test, because a few top-ups cost about as much as the repair.

Ready to talk to a real aircon engineer?

Tell us your situation on WhatsApp โ€” we'll respond with a quote in 5 minutes.

๐Ÿ’ฌ WhatsApp 9107 2601

Or do it yourself, right now โ€” book a servicing slot for the next working day, or get an installation price by uploading your floor plan.

Popular aircon services

๐Ÿ’ฌ WhatsApp Us